User manual

Run the 1784-KTx Card Diagnostics for Windows NT A-15
1784-6.5.22 - November 1999
6. Decide whether or not you want to load and view the network protocol
(network who).
– Yes displays the protocol.
– No displays the previous menu.
When you load the protocol, you see:
7. Review the information and if you are connected to a DH+ network and you
only see one active node then you will want to check:
– that the KTx DH+ node is unique (this utility only allows the KTx
to be at node 77)
– that the baud rate is not mismatched (this utility only allows 57.6
kbaud)
– for bad cable or wiring. Check cable pinouts and press any key to
continue.
If