User manual

Publication CNET-UM001C-EN-P - November 2005
4-10 Control I/O
Add Local and Remote
ControlNet Modules
Before you can connect to and control distributed I/O, you must add local and
remote ControlNet communication modules. The type of distributed I/O
determines your choice of a remote ControlNet adapter. For more
information, see the table Choose the Appropriate Remote Adapter.
Table 4.7 Choose the Appropriate Remote Adapter
The figure Add Local and Remote ControlNet Modules to an RSLogix 5000
Project shows a brief series of screens used when adding local and remote
ControlNet communication modules to an RSLogix 5000 project. For more
detailed information on how to add local and remote ControlNet modules to
your project, see the chapter Configure a ControlNet Module.
Figure 4.1 Add Local and Remote ControlNet Modules to an RSLogix 5000 Project
If The Distributed I/O Is Select This Remote
Adapter
Which You Configure Via
1756 ControlLogix I/O 1756-CN2, 1756-CN2R
1756-CNB, 1756-CNBR
RSLogix 5000 software
1794 FLEX I/O 1794-ACN15,
1794-ACNR15
1797 FLEX Ex I/O 1797-ANCR
1734 POINT I/O 1734-ACNR
1. Add Local ControlNet Communication Module
2. Add Remote ControlNet Communication Module.