User manual

Publication CNET-UM001C-EN-P - November 2005
3-20 Configure a ControlNet Module
5. Select a communication path to the ControlNet network.
The window above uses a previously configured communication path to
the controller. In this example, the computer is connected to the
ControlNet network via a 1784-PCIC card. The driver was previously
configured via RSLinx software, as described in the chapter Connect a
Computer to the ControlNet Network.
6. Set the network to Single Browse Pass.
7. Enable edits on the file. When you enable edits, the RSNetWorx for
ControlNet software reads data in the ControlNet modules and builds a
schedule for the network.
A.Expand the tree to find
your communication
path.
B.Select your
communication path.
C. Click OK.
Select Network > Single Pass Browse.
Check Edits Enabled.