User manual

Publication CNET-UM001C-EN-P - November 2005
2-4 Connect a Computer to the ControlNet Network
3. Name the new ControlNet driver.
4. After you create the driver, configure it to correspond to the ControlNet
module within your computer.
The driver is now available and you can select the ControlNet port from Who
Active in RSLogix 5000 programming software.
A.Name the driver. This
example shows the
default name
AB_PCIC-1.
B.Click OK.
A.If multiple cards are
located in your computer,
choose the correct one.
B.Make sure you use the
correct Network Address.
C. Click OK.
The appearance of this screen varies widely depending on the type of card used.