Troubleshooting guide

28  Hardware Configuration Reference Guide
1784-KT
This card provides an interface from a PC bus to a Data Highway Plus (DH+)
network. The 1784-KT card contains a set of DIP switches and a jumper which
must be set before you can use the 1784-KT with your Rockwell Software
product.
For more information on the 1784-KT card, please refer to Communication Interface
Module Installation Data, publication 1784-2.31.
Factory base address
setting of D400
123456
Base Address
7543
Interrupt
ON
OFF
IMPORTANT
Be careful when reading the switches on the 1784-KT card. The side
of the switch that is pushed into the switch block is the activated
side. (The small red dots on the switches do not denote the switch’s
position.)