User Manual User guide

94 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 4 Stratix 5100 Device Manager Parameter Definitions
Network Interface: GigabitEthernet Settings
You can use the settings page to define physical settings and AP authentication.
Table 17 - GigabitEthernet Parameter Descriptions
Parameter Description
Physical Settings
Enable Ethernet Enable
Disable
Current Status Enabled
Up
Requested Duplex Duplex setting for the Ethernet interface; Auto, Half, and Full.
Important: Do not modify Requested Duplex while using inline
power. Changing these settings while using inline power can
cause the device to reboot.
Requested Speed Auto
1000 Mbps
100 Mbps
10 Mbps
Important: Do not modify Requested Speed while using inline
power. Changing these settings while using inline power can
cause the device to reboot.
AP Authentication
Credentials Choose a credential or click Define Credentials to go to AP
Authentication where you can define the credentials you need.
Authentication Methods Profile Choose a profile or click Authentication Methods Profile to go to
AP Authentication where you can define the profiles you need.