User Manual User guide

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 91
Stratix 5100 Device Manager Parameter Definitions Chapter 4
Network Interface GigabitEthernet Status Page
Use this page to review the status for the GigabitEthernet interface.
Figure 37 - Network Interface GigabitEthernet Status Page
Table 16 - GigabitEthernet Status Parameter Descriptions
Parameter Description
Configuration
Software Status Indicates whether the interface has been enabled or disabled by the operator.
Hardware Status Indicates whether the line protocol for the interface is up or down.
Maximum Rate The rate setting for the Ethernet interface, either 10 Mbps or 100 Mbps.
Duplex The duplex setting for the Ethernet interface, either half or full.
Interface Statistics
Interface Resets The number of times an interface has been completely reset.
No Carrier The number of times the carrier was not present during the transmission.
Lost Carrier The number of times the carrier was lost during transmission.