User Manual User guide

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 59
Stratix 5100 Device Manager Configuration Startup Chapter 3
8. Enter the network configuration settings.
This table describes the network configuration settings on the Easy Setup page.
For more information about the parameters, see Easy Setup Network
Configuration Page on page 80,
Table 5 - Network Configuration Settings
Parameter Description
Host Name The host name, while not an essential setting, helps identify the wireless device on your
network. The host name appears in the titles of the management system pages.
Server Protocol Choose the item that matches the network method of IP address assignment.
IP Address Use this setting to assign or change the wireless device IP address. If DHCP is enabled for your
network, leave this field blank.
IP Subnet Mask Enter the IP subnet mask provided by your network administrator so the IP address can be
recognized on the LAN.
Default Gateway Enter the default gateway IP address provided by your network administrator. If DHCP is enabled,
leave this field blank.
IPv6 Protocol DCHP
Autoconfig
Static IP
IPv6 Address (X:X:X:X::X/<0-128>)
Username The username want to use for this WAP.
Password The password you want to use for this WAP.
SNMP Community To use Simplified Network Management Protocol (SNMP), enter a community name. SNMP is an
application-layer protocol that supports message-oriented communication between SNMP
management stations and agents.
Current SSID List List of your SSIDs you have configured.