User Manual User guide

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 57
Stratix 5100 Device Manager Configuration Startup Chapter 3
Logging into the Access Point
A user can login to the access point by using one of the following methods:
• graphical user interface (GUI)
• Telnet (if the AP is configured with an IP address)
• console port
For information on logging into the access point through the:
• GUI, see Login to the Stratix 5100 WAP
on page 53.
• CLI, see Accessing CLI on page 182
.
• Console port, see Connect to the Stratix 5100 WAP Access Point Locally
on page 54.
Using Online Help
Click the help icon at the top of any page in the web browser
interface to display online help. Click the printer icon to print
the page you are on.
The help page appears in a new browser page, use the select a topic pull-down
menu to display the help index or instructions for common configuration tasks,
such as configuring VLANs.
Configure the Basic Settings
for an Access Point
After you determine or assign the access point IP address, you can browse to the
access point Express Setup page and perform the initial configuration.
1. Open your Internet browser.
2. Type the WAP address in the browser address line and press Enter.
An Enter Network Password screen appears.
3. Press Tab to bypass the Username field and advance to the Password field.
4. Enter the case-sensitive password: wirelessap.
5. Press Enter.