User Manual User guide

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 549
Configuring System Message Logging Chapter 21
00:00:46: %LINK-3-UPDOWN: Interface Port-channel1,
changed state to up
00:00:47: %LINK-3-UPDOWN: Interface
GigabitEthernet0/1, changed state to up
00:00:47: %LINK-3-UPDOWN: Interface
GigabitEthernet0/2, changed state to up
00:00:48: %LINEPROTO-5-UPDOWN: Line protocol on
Interface Vlan1, changed state to down
00:00:48: %LINEPROTO-5-UPDOWN: Line protocol on
Interface GigabitEthernet0/1, changed state to down
2
*Mar 1 18:46:11: %SYS-5-CONFIG_I: Configured from
console by vty2 (10.34.195.36)
18:47:02: %SYS-5-CONFIG_I: Configured from console
by vty2 (10.34.195.36)
*Mar 1 18:48:50.483 UTC: %SYS-5-CONFIG_I:
Configured from console by vty2 (10.34.195.36)
Default System Message Logging Configuration
This table shows the default system message logging configuration.
Disabling and Enabling Message Logging
Message logging is enabled by default. It must be enabled to send messages to
any destination other than the console. When enabled, log messages are sent
to a logging process, that logs messages to designated locations
asynchronously to the processes that generated the messages.
Table 114 - Default System Message Logging Configuration
Feature Default Setting
System message logging to the
console
Enabled
Console severity Debugging (and numerically lower levels; see Table 115 on page 555
)
Logging buffer size 4096 bytes
Logging history size 1 message
Timestamps Disabled
Synchronous logging Disabled
Logging server Disabled
Syslog server IP address None configured
Server facility Local7 (see Table 116 on page 560
)
Server severity Informational (and numerically lower levels; see Table 115 on page 555
)