User Manual User guide

492 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 17 Configuring Filters
8. Repeat step 5 through step 7 to add protocols to the filter.
9. If you do not need to add IP port elements to the filter, skip to step 6
to
save the filter on the access point.
Filter a TCP or UDP Port Number
Follow these steps to filter a TCP or UDP port number.
1. From the TCP Port or UDP Port pull-down menus, select one of the
common port protocols or select Custom and enter the number of an
existing port in one of the Custom fields.
2. If you have an existing port, enter a port number from 0…65535.
3. From the Action pull-down menu, select Forward or Block.
4. Click Add.
The port appears in the Filters Classes field.