User Manual User guide

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 491
Configuring Filters Chapter 17
3. From the Action pull-down menu, select Forward or Block and click Add.
• The address appears in the Filters Classes field.
• To remove the address from the Filters Classes list, select it and click
Delete Class.
4. Repeat step 1
through step 3 to add addresses to the filter.
If you do not need to add IP protocol or IP port elements to the filter, click
Apply.
5. From the IP Protocol pull-down menu, select one of the common
protocols to filter an IP protocol.
6. If you have an existing protocol, use Custom and enter a protocol number
from 0…255.
7. From the Action menu, select Forward or Block and click Add.
• The protocol appears in the Filters Classes field.
• To remove the protocol from the Filters Classes list, select it and click
Delete Class.