User Manual User guide

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 475
Configuring QoS Chapter 16
5. To use video access category (AC = 2) for signaling, check Admission
Control under Video(CoS 4-5).
Enabling Admission Control
Follow these steps to enable admission control on an SSID:
1. Open the SSID Manager page.
2. Select an SSID.
3. Under General Settings, select Enable in the Call Admission Control field.
Troubleshooting Admission Control
You can use two CLI commands to display information to help you troubleshoot
admission control problems:
• To display current admission control settings on radio 0, enter the
following command:
# show dot11 cac int dot11Radio 0
• To display current admission control settings on radio 1, enter the
following command:
# show dot11 cac int dot11Radio 1
• To display information about admitted streams with admission control
and MT, enter the following command:
# show dot11 traffic-streams
IMPORTANT
The admission control settings you have configured does not take effect until
you enable admission control on an SSID.