User Manual User guide

428 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 14 Configuring RADIUS and TACACS+ Servers
This example shows how to configure the WISPr location-name attribute:
ap# snmp-server location
ACMEWISP,Gate_14_Terminal_C_of_Newark_Airport
This example shows how to configure the ISO and ITU location codes on the
access point:
ap# dot11 location isocc us cc 1 ac 408
This example shows how the access point adds the SSID used by the client device
and formats the location-ID string:
isocc=us,cc=1,ac=408,network=ACMEWISP_NewarkAirport
Displaying the RADIUS Configuration
To display the RADIUS configuration, use the show running-config
privileged EXEC command.
RADIUS Attributes Sent by the Access Point
Table 99 on page 428 through Table 101 on page 429 identify the attributes sent
by an access point to a client in access-request, access-accept, and accounting-
request packets.
TIP
When DNS is configured on the access point, the show running-
config
a server’s IP address can appear instead of its name.
TIP
You can configure the access point to include in its RADIUS accounting and
authentication requests attributes recommended by the Wi-Fi Alliance’s WISPr
Best Current Practices for Wireless Internet Service Provider (WISP) Roaming
document.
See Configuring WISPr RADIUS Attributes
on page 426 for instructions.
Table 99 - Attributes Sent in Access-Request Packets
Attribute ID Description
1User-Name
4 NAS-IP-Address
5NAS-Port
12 Framed-MTU
30 Called-Station-ID (MAC address)
31 Calling-Station-ID (MAC address)
32 NAS-Identifier
(1)