User Manual User guide

380 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 13 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services
This figure shows the components that interact to perform Layer 3 mobility.
Figure 99 - Required Components for Layer 3 Mobility
For more information about Cisco Structured Wireless-Aware Network
(SWAN) see: http://www.cisco.com/en/US/netsol/ns340/ns394/ns348/
ns337/networking_solutions_package.html
CiscoWorks Wireless LAN Solution Engine
(WLSE)
CiscoSecure ACS
AAA Server
Catalyst 6500
Wireless Domain Services (WDS) on the
Wireless LAN Solutions Module (WLSM)
Catalyst 6500
Wireless Domain Services (WDS) on the
Wireless LAN Solutions Module (WLSM)
Infrastructure access points
(registered with WDS)
117993
TIP
If you enable Layer 3 mobility for an SSID and your WDS device does not
support Layer 3 mobility, client devices cannot associate by using that SSID.
Repeater access points and access points in workgroup bridge mode cannot
associate to an SSID when Layer 3 mobility is enabled.