User Manual User guide

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 23
Getting Started with the Stratix 5100 WAP Chapter 1
Regulatory Domains
The Stratix 5100 supports the following regulatory domains:
• 1783-WAPAK9 (North America)
• 1783-WAPZK9 (Australia/New Zealand)
• 1783-WAPEK9 (European Union)
• 1783-WAPCK9 (China)
Configuring the Access Point
You can configure and monitor the wireless device by using the following:
• Command-line interface (CLI),
• Stratix 5100 WAP Device Manager, browser-based management system:
web based or Simple Network Management Protocol (SNMP).
Management Options
You can use the wireless device management system through the following
interfaces:
• A web browser interface, that you use through a web browser.
See Stratix 5100 Device Manager Configuration Startup on page 51
for a
detailed description of the web browser interface.
• The Cisco IOS command-line interface (CLI), that you use through a
console port or Telnet session.
• Use the
interface dot11radio global configuration command to
place the wireless device into the radio configuration mode. For mor
information on CLI, see Configure the Stratix 5100 WAP Using the
Command-Line Interface on page 175.
• Simple Network Management Protocol (SNMP). Configuring SNMP on
page 507 explains how to configure the wireless device for SNMP
management.