User Manual User guide

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 157
Stratix 5100 Device Manager Parameter Definitions Chapter 4
SNMP Trap Community The SNMP community string identifiers the sender to the trap destination. This string
is required by the trap destination before it records traps sent by the device.
Enable All Trap Notifications Select this option to enable all the notifications available on the access point.
Enable Specific Traps Select this option to specify the notifications to be sent.
• 802.11 Event Traps
Enables traps for client authentication failure, client deauthentication, and client
disassociation.
• Encryption Key Trap
Enables traps on any change in the WEP encryption key settings.
• QoS Change Trap
Enables traps on any change made to the 8 traffic class definitions.
• Syslog Trap
Enables sending of traps when event logs of a certain severity level (established by
the Event Log Configuration page) occur.
• Standby Switchover Trap
Enables sending of traps when an access point in standby mode switches over to
active mode.
• Rogue AP Trap
Enables sending of traps when a radio client reports a rogue access point.
Table 58 - SNMP Trap Community Parameter Descriptions (Continued)
Parameter Description