User Manual User guide

112 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 4 Stratix 5100 Device Manager Parameter Definitions
Table 29 - Security Summary Parameters Descriptions
Parameters Description
Username The username of the active user.
Read-Only Specifies whether the user has read-only capabilities.
Read-Write Specifies whether the user has read/write capabilities.
SSID Specifies the unique identifier the client devices use to associate with the access
point.
VLAN Specifies the VLANs that are currently assigned.
SSID Unique Identifier
Band Select When enabled, it lets the 2.4 GHz radio switch to a less congested 5-GHz access
point.
Web-Auth A Client Authentication type/
Radio Specifies which radio is being used.
BSSID/Guest Mode Specifies the BSSID/Guest mode attached to this SSID.
Open/Shared/Network EAP Specifies the method of authentication being used.
• Open enables any device to authenticate and then attempt to communicate
with the access point.
• Shared sends an unencrypted challenge string to any device attempting to
communicate with the access point.
• Network EAP uses EAP to interact with an EAP-compatible server on your
network to provide authentication for wireless client devices.
Management Frame Protection
(MFP)
Management frames can be protected to detect adversaries who are invoking
denial of service attacks. These can include, flooding the network with
associations and probes, interjecting as rogue access points, and affecting the
network performance by attacking the QoS and radio measurement frames.This
link leads to the Intrusion Detection page.