User Manual User guide

120 Rockwell Automation Publication 1783-UM004E-EN-P - June 2014
Chapter 4 Manage the Switch via the Device Manager Web Interface
Alarm In 1
Alarm In 2
Off Alarm input not configured.
Solid green Alarm input configured; no alarm detected
Blinking red Major alarm detected.
Solid red Minor alarm detected.
Setup Off The switch is configured as a managed switch.
Solid green The switch is in initial setup.
Blinking green The switch is in initial setup, fault recovery, or initial setup is incomplete.
Solid red The switch failed to start initial setup or recovery because there is no available switch port to connect to the
management station. Disconnect a device from a switch port, then press the Express Setup button on the switch.
Ports—Each combo port has two status indicators: one for the SFP module and one for the RJ45 connector. The appropriate status indicator is active for the active port.
Off No link present on the port.
Solid green Port link; no activity.
Flashing green and off Link is active and healthy.
Alternating green and amber There is a fault or error on the link.
Solid amber The port is disabled.
EIP Net—The EIP Net status indicator shows the network status of the switch.
Off Power to the switch is off or is not properly connected.
Solid green The switch has an established CIP connection to one or more attached devices.
Blinking green The switch has an IP address but the switch does not have an established connection to one or more attached devices.
Blinking red One or more connections to attached devices have timed out.
Solid Red The switch has detected that its IP address is already in use by another device in the network.
Blinking green and red The switch is running its power-on self-test (POST).
Status —In this mode, the port status indicators show the status of the ports. This is the default mode.
Off No link.
Solid green No activity on link.
Flashing green Link activity.
Solid brown Port has been disabled.
Yellow An error has disabled the port.
Flashing green and amber Faulty link.
Flashing amber Smartports configuration mismatch on port.
Solid amber Port is faulty, disabled due to an error, or is in an STP-blocked state.
Smartports—In this mode, each port image shows the applied port role. For information about Smartports, see
Optimize Ports through Smartports Port Roles on page 83.
Table 9 - Front Panel Status Indicators (continued)
Indicator Status Description