Owner's manual

Block Format Instructions
Chapter 10
1020
Let’s continue and load your data into the binary data monitor mode for each
sequencer instruction. You will get your data from your worksheets
(Figure 10.1 and Figure 10.2). A filled in block means that a 2 will be inserted
in a corresponding bit position.
Start by positioning your cursor on the words SEQUENCER INPUT. Use the
cursor control keys to move the cursor.
112
13
SEQUENCER INPUT
COUNTER ADDR:
CURRENT STEP:
SEQ LENGTH:
0200
001
006
WORDS PER STEP
FILE:
MASK
2
0400-0413
0070-0071
INPUT WORDS:
1: 0110 2: 0201
3: 4:
EN
DN
0200
17
0200
15
SEQUENCER INPUT
COUNTER ADDR:
CURRENT STEP:
SEQ LENGTH:
0200
001
006
WORDS PER STEP
FILE:
MASK
2
0600-0613
0075-0076
INPUT WORDS:
1: 0012 2: 0013
3: 4:
KEY
DISPLAY
Let’s go on...
DISPLAY
The screen does not change.
0
BINARY DATA MONITOR
SEQUENCER INPUT
COUNTER ADDR: 02004 STEP: 001 SEQUENCER LENGTH: 006
FILE: 600-610
INPUT ADDR: 110
DATA: 00000000 00000000 00000000 00000000
201
MASK ADDR: 070
DATA: 00000000 00000000 00000000 00000000
STEP
001
002
003
004
005
006
00000000 00000000 00000000 00000000
WORD 1
WORD 2
00000000 00000000 00000000 00000000
00000000 00000000 00000000 00000000
00000000 00000000 00000000 00000000
00000000 00000000 00000000 00000000
00000000 00000000 00000000 00000000
DATA: 00000000 00000000
PROGRAM MODE
071