Instruction Manual
Data Manipulation Instructions
Chapter 9
913
Editing the Operation
You edit a Get Byte/Put instruction by performing the following steps.
6. Position the cursor over -[B]-.
7. Press -[B]-.
8. Enter <address>.
9. Enter <byte designation>.
Important: Repeat steps 2, 3 and 4 when using two Get Byte instructions.
10. Press -(PUT)-.
11. Enter <address>.
We showed you how to transfer and compare data. Also, we showed you how
to use these instructions to perform comparison operations. The next chapter
shows you how to perform operations involving three digit and expanded math.
Chapter Summary