Instruction Manual

Quick Reference
Appendix C
C17
Table C.P
Search
Functions
Function Key Sequence Mode Description
Locate first rung program
[SEARCH][↑]
Any Positions cursor on the first instruction of the program.
Locate last rung program area
[SEARCH][
↓]
Any Positions cursor on the temporary end instruction, subroutine
area boundary, or the end statement depending on the
cursor's location. Press key sequence again to move to the
next boundary.
Locate first instruction of
current rung.
[SEARCH] [
←]
Remote Prog Position cursor on first instruction of the current rung.
Move cursor off screen
[SEARCH][
←]
Remote Test
Run/Program
Moves cursor off screen to left.
Locate output instruction of
current rung
[SEARCH][
→]
Any Position cursor on the output instruction of the current rung.
Locate rung without an
output instruction
[SHIFT]
[SEARCH]
Any Locates any rung left incomplete due to an interruption
in programming.
Locate specific instruction [SEARCH]
[Instruction key]
(Address)
Any Locates instruction searched for. Press [SEARCH] to locate
the next occurrence of instruction.
Locate specific word address [SEARCH]
(address)
Any Locates this address in the program (excluding | | and | / |
instructions and addresses in files). Press [SEARCH] to locate t
h
next occurrence of this address.
1
Single rung display [SEARCH]
[DISPLAY]
Any Displays the first rung of a multiple rung display by itself. Press
key sequence again to view multiple rungs.
Print [SEARCH]
[4] [3]
Any Prints single rung.
Print [SEARCH]
[4] [4]
Any Prints ladder diagram dump.
Print [SEARCH]
[4] [5]
Remote Prog Prints total memory dump.
Print [SEARCH]
[5] [0]
Any Prints first 20 lines of data table configuration.
Print [SEARCH]
[5] [3]
Any Prints first 20 lines of bit manipulation.
Print [SEARCH]
[5] [4]
Any Prints first 20 lines of memory layout display.
Program controls outputs [SEARCH]
[5][9][0]
Run/Program Places the processor in run/program mode.
Program executes
outputs disabled
[SEARCH]
[5][9][1]
Remote Test Places the processor in remote test mode.
Processor awaits commands [SEARCH]
[5][9][2]
Remote
Program
Places the processor in remote program mode.
Enter leading zeros when bit address exceeds 5 digits or word address exceeds 3 digits.
1