Instruction Manual

Report Generation
Chapter 17
17-5
Figure 17.4
Message
Request BitDone Bit Relationship
10219I
Message Request Bits Message Done Bits
17 10 07 00
Message
Control
Word
The message print command is valid for message 0. It prints out the
message control word addresses in a form similar to that shown in
Table 17.A. If the location of the message control file is to be changed or
you no longer need message 0, it can be deleted with the message delete
command and re-entered at any time.
Table 17.A
Example
Message Control W ordMessage Number Relationship
Control
Words
Message
Numbers
200 010017
201 110117
202 210217
203 310317
204 410417
205 510517
206 610617
207 710717
IMPORTANT: This table assumes user selected message control words begin at 200
8
.
ATTENTION: Do not use message control words for any other
purpose. This warning is especially critical for output image
table locations when output or block transfer modules are
placed in corresponding slots. Failure to observe this warning
could result hazardous or unexpected machine operation. This
could result in damage to equipment and/or injury to personnel.