Instruction Manual

Math Instructions
Chapter 10
1018
10.Enter <data> if appropriate.
11. Press -[G]-.
12.Enter <address>.
13.Enter <data> if appropriate.
14.Close the branches. Press the branch end key [
].
15.Close the rung. Press [SHIFT][EAF].
16.Enter 05 (function number).
17.Enter 010 (data address).
18.Enter <result address>.
Editing a Completed Rung
Operand and Result: Follow the editing procedures for a Get instruction.
EAF Instruction: You can edit a square root operation to change an address by
performing the following steps.
1. Press [SHIFT][EAF].
2. Enter 05 (function number).
3. Enter 010 (data address).
4. Enter <result address>.
BCD to Binary
You must decide whether or not to enter a data address. If you choose to enter a
data address, the processor seeks the conversion number at that address in the
data table. If you choose not to enter a data address and use the default number
(010), the processor seeks its conversion number from the instructions in
the rung.
The ladder diagram that enables the processor to perform a BCD to Binary
conversion is shown in Figure 10.7. The default number is used as the
data address.