User Manual Owner's manual

Program Control Instruction
Chapter 10
10-8
Removing an Immediate Output Instruction
The only way to remove an Immediate Output Update instruction is to
remove the entire rung. See chapter 11.
Removing an Immediate Input Instruction
Remove an Immediate Input Update instruction by performing the
following steps.
1. Position the cursor over the Immediate Input Update instruction you
want to remove.
2. Press [REMOVE]-[I]-.
Editing a Partially Completed Rung or a Completed Rung
Edit an Immediate Input or Immediate Output instruction by performing
the following steps.
If you are editing a completed rung, proceed to step 1. If you are editing a
partially completed rung, enter the next instruction and proceed to step 1.
1. Position the cursor over the Immediate Input or Immediate Output
Update instruction you want to change.
2. Press -(I)-, -[IOT]-, or any other appropriate instruction type key.
3. Enter <address>.