User Manual Owner's manual
Table Of Contents
- 1772-6.5.8, Mini-PLC-2/02, -2/16, -2/17 Processor, User Manual
- Important User Information
- Summary of Changes
- Table of Contents
- 1 - Using This Manual
- 2 - Fundamentals of a Programmable Controller
- 3 - Hardware Features
- 4 - Installing Your Programmable Controller
- 5 - Starting Your Processor
- 6 - Maintaining and Troubleshooting Your Processor
- 7 - Memory Organization
- 8 - Scan Theory
- 9 - Relay-Like Instructions
- 10 - Program Control Instructions
- 11 - Timers and Counters
- 12 - Data Manipulation and Compare Instructions
- 13 - Three-Digit Math Instructions
- 14 - EAF Math Instructions
- 15 - EAF Log, Trig, and FIFO Instructions
- 16 - EAF Process Control Instructions
- 17 - Jump Instructions and Subroutines
- 18 - Block Transfer
- 19 - Data Transfer Instructions
- 20 - Bit Shift Registers
- 21 - Sequencers
- 22 - Selectable Timer Interrupts
- 23 - Report Generation
- 24 - Program Editing
- 25 - Programming Techniques
- 26 - Program Troubleshooting
- A - Specifications
- B - Processor Comparison Chart
- C - Number Systems
- D - Glossary
- E - Quick Reference
- Index
- Back Cover
Program Control Instruction
Chapter 10
10-4
Figure 10.2
Zone Control Reset
010
00
016
00
ZCL
011
00
012
00
010
00
010
00
015
00
011
00
017
00
020
00
021
00
012
00
022
00
023
00
013
00
024
00
025
00
026
00
014
00
ZCL
End Fence
If the start fence becomes:
True - Each rung condition controls their output instruction.
False - All output instructions within the zone are left in their last state.
ATTENTION: MCR or ZCL zones must not overlap or nest.
Each zone must be separate and complete. Overlapping MCR
or ZCL zones could result in unpredictable machine operation
with possible damage to equipment and/or injury to personnel.
Keystrokes
Enter an MCR or ZCL instruction by performing the following steps.
1. Press either -(MCR)- or -(ZCL)-.