Manual

Calibrating the Module
Chapter 8
8-3
The calibration read block contains 14 words as shown in Table 6.B.
Table 6.B
Calibration
Read Block
Word Bits Description
1 0-15 Block Identification Code  1100 0000 0000 0000 (C000
16
)
2
0 Bad Calibration Procedure
• 0 = OK
• 1 = Wrong calibration procedure was attempted with the calibration write block.
1 Calibration Hardware Failure
• 0 = OK
• 1 = Calibration cannot take place due to hardware failure.
2 Calibration Reference Out of Range
• 0 = OK
• 1 = Incorrect reference signal was used during calibration.
3-15 Reserved
3
0 Loop1 Input Calibration Done
1 Loop2 Input Calibration Done
2 Loop3 Input Calibration Done
3 Loop4 Input Calibration Done
4 Loop5 Input Calibration Done
5 Loop6 Input Calibration Done
6 Loop7 Input Calibration Done
7 Loop8 Input Calibration Done
8-15 Reserved
4 0-15 Reserved
Calibration Read Block