Manual
3–19Status Word/Bit Descriptions
Publication
1771-6.5.126 – March 1998
SYS
Word Bit Description
SYS13 B07 = 0 Normal
= 1 Hold Profile Command Error
The module latches this bit when both of the following are true:
DYC02-B06 is SET
SYS15-B11 is RESET
The module unlatches this bit when it decodes a valid Dynamic Command Block with any SET action execution bit
other than DYC02-B06.
B08 = 0 Normal
= 1 Pre-decompression Movement Command Error
The module latches this bit at completion of the Hold Profile if all of the following are true:
HPC03-B08 is RESET
HPC03-B09 is SET
SYS15-B12 is RESET
The module also latches this bit if all of the following are true:
DYC02-B07 is SET
HPC03-B09 is SET
SYS15-B12 is RESET
The module also latches this bit if both of the following are true:
DYC02-B07 is SET
SYS15-B11 is RESET
The module also latches this bit if both of the following are true:
DYC02-B07 is SET
PRC05 added to the actual ram (screw) position equals or exceeds MCC12
Module unlatches this bit when it decodes a valid DYC Block with any SET action execution bit other than DYC02-B07.
B09 = 0 Normal
= 1 Plastication Profile Command Error
The module latches this bit at completion of the Hold Profile if all of the following are true:
HPC03-B08 is RESET
SYS15-B12 is RESET
HPC03-B09 is RESET
SYS15-B14 is RESET
The module also latches this bit at completion of the Pre-decompression Movement if both of the following are true:
HPC03-B09 is RESET
SYS15-B14 is RESET
The module also latches this bit if all of the following are true:
DYC02-B07 is RESET
PRC05 equal zero
HPC03-B09 is RESET
SYS15-B14 is RESET
The module also latches this bit if all of the following are true:
DYC02-B07 is RESET
SYS15-B12 is RESET
HPC03-B09 is RESET
SYS15-B14 is RESET
The module also latches this bit if both of the following are true:
DYC02-B08 is SET
SYS15-B14 is RESET
The module unlatches this bit when it decodes a valid DYC Block with any SET action execution bit other than
DYC02-B07 or DYC02-B08.