Manual

1–22 Abbreviated Command and Status Blocks
Publication 1771-6.5.126 – March 1998
Bit-Mapped Status Words (continued)
SYS23*_0**
B34:22* B21:18** Status of trace data collection in progress
SYS24*_0** B34:23* B21:19** Status of process trace data collected
*Pro-set 600 **Pro-Set 700 For example, MCC05_0 is correct for Pro-Set 700.
Input Level in Engineering Units
SYS25 N40:177 Input #1
SYS26 N40:178 Input #2
SYS27 N40:179 Input #3
SYS28 N40:180 Input #4
SYS29-32 N40:181-184 RFU
Input Level, Raw Signal Level at A/D Converter
SYS33 N40:185 Input #1
SYS34 N40:186 Input #2
SYS35 N40:187 Input #3
SYS36 N40:188 Input #4
SYS37-40 N40:189-192 RFU
Output Level in Percent
SYS41 N40:193 Output #1
SYS42 N40:194 Output #2
SYS43 N40:195 Output #3
SYS44 N40:196 Output #4
SYS45-48 N40:197-200 RFU
Maximum Pressures of Each Cycle
SYS49 N40:201 Maximum ram (screw) pressure, last cycle
SYS50, 51 N40:202, 203 RFU
SYS52 N40:204 Maximum cavity pressure, last cycle
SYS53 N40:205 RFU
Process Trace
SYS54 N40:206 Process trace data collection in progress
SYS55 N40:207 Process trace data collection done
SYS56 N40:208 RFU
Accumulated Process Times
SYS57 N40:209 Tonnage
SYS58 N40:210 Cure
SYS59 N40:211 Mold open dwell
SYS60 N40:212 Cycle
Programming Error Codes
SYS61 N40:213 ID of data block with error
SYS62 N40:214 Programming error code
Firmware ID
SYS63 N40:215 Module Series/Revision
Confirmation of New Status
SYS64 N40:216 Counter accumulated value, each new SYS