User guide

Select Command and Status Bits to
Sequence Machine Operation
Chapter 6
6-5
Table 6.E
Miscellaneous
Status Bits T
o T
rigger New Action
Reason for Using: Bit Description: QDC Block
Address:
ProSet
B34/xx:
To drop pump adders, or shift solenoids before
starting pack/hold profile
Injection complete SYS02B04
To drop pump adders, or shift solenoids Clamp in moldprotect zone SYS03B00 32
To add pump adders, or shift solenoids for tonnage
build or lockup
Mold safe SYS03B01 33
To start inject cycle Tonnage complete SYS03B02 34
To inhibit clamp from opening in auto mode Cure timer timing SYS03B03 35
To start clampopen phase Ram (screw) retracted, and
Cure time complete
SYS03B04,
and B05
36,
37
To drop pump adders, or shift solenoids Clamp in openslow zone SYS03B06 38
To idle the machine until starting next action Mold fully open SYS03B07 39
To shift solenoids before starting next ejector stroke
after the 1st advance strode
Ejector profile stopped at end of stroke SYS03B08 40
To prevent starting next cycle with machine in auto
mode
Opendwell timer is timing SYS03B09 41
To prevent starting ejector retract
until valves have shifted
Ejector forward dwell timer is timing SYS03B10 42
To start next cycle with machine in auto mode Cycle complete SYS03B11 43
To start ejector retract Ejector fully advanced SYS03B12 44
To start ejector retract when tip stroking is ON Ejector is beyond tip advance position SYS03B13 45
To start ejector advance when tip stroking is ON Ejector is within tip retract position SYS03B14 46
To start ejector advance Ejector fully retracted SYS03B15 47
To reopen the clamp when the part is stuck LP close watchdog timeout SYS04B03 51
To idle the machine and activate an alarm because
the hopper is running out of plastic
Watchdog for plastication phase SYS04B08 56
To shift solenoids for predecompression Setoutput in progress @ end of hold SYS22B06 342
To shift solenoids for plastication Setoutput in progress @ end of
predecompression
SYS22B07 343
To shift solenoids for postdecompression Setoutput in progress @ end of
plastication
SYS22B08 344
To idle the machine until starting next action Setoutput in progress @ end of
postdecompression
SYS22B09 345