User guide

Enter Y our Initial Values Here
Jog Your Machine
Chapter 5
5-8
Worksheet 5. B
Screwrotate Jog Configuration Values for Indirect Control
Block Word ProSet 600 Addr. Value Description
Screw Rotate Jog
JGC09 N40:65 Set Output Values Output #1
1
JGC10 N40:66 Output #2
1
JGC11 N40:67 Output #3
1
JGC12 N40:68 Output #4
1
1
% Signal Output
00.00 to 99.99 %
If your hydraulics require it, take time now to develop ladder logic
(independent of Pro-Set 600 software) so the QDC module can assist in
screw-rotate jogs. Otherwise, omit the rest of this chapter.
Use word 1 in the dynamic command block (DYC01) to enable and disable
individual jogs. Use word 1 in the system status block (SYS01) to monitor
the QDC module’s reaction to jog commands. Tables 5.C and 5.D identify
command and status bits for jogging screw rotation.
Table 5.C
Enable
Bits for Screwrotate Jogs
Command Block Word: ProSet 600 Address: Description:
DYC01B09 B34/393 Execute Screwrotate Jog
Table 5.D
Status
Bits for Screwrotate Jogs
Status Block Word: ProSet 600
Address:
Description:
SYS01B09 B34/9 Screwrotate Jog in Progress
We provide a programming example (Figure 5.2) of assisted jog control for
instructional purposes only. Your application-specific programming may
vary significantly from this example.
Write Ladder Logic to Assist
with Screwrotate Jogs