User guide

Index
I–5
clamp open velocity, 948
ejector pressure, 953
ejector velocity, 958
injection pressure, 920
injection velocity, 925
pack and hold pressure, 931
plastication backpressure, 937
Valvespanning procedures, for, clamp low
pressure close, 94
velocity setpoints
clamp, 1024
CPC, 87
EPC, 845
injection, 1010
IPC, 814
OPC, 836
velocity units, selection of, 85, 813,
834, 842
W
watchdog timer, 1019
for profiles, 730, 1034
wiring, QDC module I/O, 27
word numbering, P4
worksheets
configuration worksheet list, 72
configure EAC, ERC, 717
configure FCC, SCC, TCC, 73, A8
configure FOC, SOC, TOC, OSC, 715,
A20
configure HDC, 711, A16
configure INC, 77, A12
configure LPC, 75, A10
configure PKC, 79, A14
configure PLC, 713, A18
jog ram, clamp, ejector, 53
jog screw-rotate, indirect, 58
pressure alarm setpts, 316
profile worksheet list, 81
profile, CPC values, 83
profile, EPC values, 840
profile, HPC values, 819
profile, IPC values, 811
profile, OPC values, 832
profile, PPC values, 825
QDC module parameters, 32
sensor config values, 35, 39
sensor I/O ranges, 33
software travel limits, 315
Worksheets, for, I/O ranges, 21
Z
zone overrun, 1028
selection of, 834