User guide

Index
I–4
profiles, initial values
clamp close, 82
clamp open, 831
ejector, 839
injection, 810
pack and hold, 818
plastication, 824
publications, related, P5
pullback, decompression, 1017
Q
QDC module
digital input filter, 317
ground, 29
I/O ranges, 32
I/O terminal designations, 28
install, 26
optional configurations, 314
rack address, 25
select parameters, 32
sensor config values, initial, 34
sensor configuration, final, 38
set jumper plugs, 22
troubleshoot, 111
wire I/O, 27
QH module, record I/O ranges, 21
R
ram (screw)
configure position sensor, 39
jog screw rotation, 59
ramp rates
initial values, 724
inject mode, 1017
tuning, 1018
tuning of, 1031
S
sensor config values, 34
sensor configuration, 38
setoutput, move ram, clamp, ejector, 37
set-output values
at end of inject profiles, 1016
end of clamp/ejector motion, 1030
for unselected valves, 1015
shot size, 830, 1013
diagram, 1014
software travel limits, 314
status blocks, P4, 42
stopandnotify, ejector profile, 843
summary, inject, clamp, & eject, 120
system pressure, 115, 720
configure pressure sensor, 312
T
time delay, pressurelimited velocity, 1021
time delays, 316
time setpoints, 1012
HPC, 822
IPC, 816
PPC, 829
timer preset, ejector forward dwell, 846
tip strokes, 115
selection of, 842
tonnage, procedure to set, 98
tonnage-complete setpt, 89
transition, 15, 1014
conditions for, 1013
diagram, 1014
setpoints, 817
troubleshoot, 111
tune closed loop
pressure control, 102
with an oscilloscope, 104
without an oscilloscope, 103
velocity control, 106
with an oscilloscope, 108
without an oscilloscope, 107
tuning considerations
for clamp and ejector, 1023
for producing parts, 1010
ramp rates, 1018
V
valve-linearity procedures, for
clamp close pressure, 913
clamp close velocity, 918
clamp low pressure close, 97
clamp open pressure, 945
clamp open velocity, 951
ejector pressure, 956
ejector velocity, 960
injection pressure, 923
injection velocity, 929
pack and hold pressure, 935
plastication backpressure, 940
valve-spanning procedures, for
clamp close pressure, 910
clamp close velocity, 915
clamp open pressure, 942, 943,
949, 954, 959