User guide
Index
I–2
inject-mode, 1011
ERC
clamp and eject mode, 1034
initial values, 722
inject-mode, 1022
select on/off, 86, 814, 821, 828,
835, 844
error correction for, data entry in
data blocks, 46
MCC block, 36
F
flash prevention, 14
G
gain constants, 721
for profiles, 729
P and VelFF, 106
PID for pressure control, 103
glossary, P2, 120
grounding, QDC module, 29
H
hold phase, overview, 17
I
I/O
auxiliary analog inputs, 21
record ranges, 21
I/O config procedures (optional)
digital input filter, 317
software travel limits, 314
system pressure alarm, 316
time delays, 316
I/O configuration procedures, 31
clamp position sensor, 310
correct data entry errors, 36
download MCC block, 36
ejector position sensor, 311
enter MCC into data table, 35
move ram, clamp, ejector, 37
screw position sensor, 39
select I/O ranges, 32
sensor config values, 34
sensor configuration, final, 38
system pressure sensor, 312
inject mode
overview, 11
pressure limited, 1020
injection profile
example benefits, 13
initial values, 810
overview, 12
inputs
clamp position sensor, 310
digital input filter, 317
ejector position sensor, 311
optional configurations, 314
screw position sensor, 39
select ranges, 33
sensor config values, 34
sensor configuration, final, 38
software travel limits, 314
system pressure alarm, 316
system pressure sensor, 312
time delays, 316
installation procedures
ground the QDC module, 29
install the QDC module, 26
jumper settings, 22
key the I/O chassis, 25
plan machine interlocks, 211
wire the QDC module, 27
J
jog procedures, 51
determine initial jog values, 52
download jog values, 54
jog the ram, clamp, ejector, 57
ladder logic for jogs, 55, 58
rotate the screw, 59
screw rotate, indirect, 57
jogging, 51
jumper plugs
accessing, 22
location diagram, 23
settings, 24
K
key the I/O chassis, 25
L
ladder logic
assess requirements, 61
command/status bit tables, 62
ram, clamp, ejector jogs, 55
screw-rotate, assist, 58
LEDs to troubleshoot, 111