User guide

A
alarm, pressure setpoint for
clamp close profile, 914
clamp LPC profle, 99
clamp open profiles, 947
ejector profile, 957
inject-mode profiles, 1019
injection profile, 924
pack and hold profile, 936
plastication profile, 941
profile vs absolute, 1033
alarm, profile pressure, 730
alarm, system pressure, 316
algorithm
select for profile, 86, 813, 827,
835, 844
select gain constants, 721
audience, P2
Auxiliary analog inputs, 21
B
bit numbering, P4
block identifier, 85
C
clamp, configure position sensor, 310
clamp close
initial profile values, 82
overview, 19
position segments, 110
clamp control
endofsegment positions, 1025
LPC pressure setpoints, 1024
start LPC position, 1026
start open slow position, 1027
tuning considerations, 1023
velocity setpoints, 1024
zone overrun, 1028
clamp mode, overview, 19
clamp open
initial profile values, 831
overview, 111
position segments, 112
command blocks, P3, 41
configuration procedures
concepts, 41
determine initial values, 719
overview of, 43
control limits
pressure min/max, 726
outputs for min/max, 726
velocity min/max, 728
outputs for min/max, 728
cure timer preset, 823
cushion, 830, 1013
diagram, 1014
D
decompression, 1017
digital filter, 317
download procedures
correct dataentry errors, 46
data blocks, 44
download bit table, 45
enter into data table, 44
enter/download values, 89
MCC block, 36
E
E-stops, 211
eject mode, overview, 113
ejector
advance, 113
configure position sensor, 311
enable/disable, 844
endofsegment positions, 1025
forward dwell, 842
forward dwell timer, 846
initial profile values, 839
other features, 115
retract, 114
stop and notify, 843
strokes required, 848
tip strokes, 115
tuning considerations, 1023
type of strokes, 842
end-of-segment positions
clamp and ejector, 1025
determine for clamp close, 88
determine for ejector, 846
determine for injection, 815
determine for open slow, 837
determine for plastication, 829
Index