User guide

Overview of Inject, Clamp, and Eject Mode
Chapter 1
1-13
Figure 1.15
Example
Open Slow
Open Slow
Clamp
Cylinder
Moving
Platen
L0Y
Velocity
Position
2
1
Stationary
Platen
Segments
Important: If you need only one open slow motion, configure only the 1st
segment of the open slow profile.
In this section, we describe the eject operation for expelling molded parts.
The operation consists of:
ejector advance
ejector retract
Figure 1.16
Clamp
and Eject Portion of a T
ypical Machine Cycle
Inject
Open Slow
Low Pressure
Close
Clamp Close
Clamp Open
Ejector advance
Ejector retract
Ejector Advance
The QDC module starts advancing the ejector after detecting either one of
these events that you configure/program:
clamp position reaching a pre-determined setpoint
command from your PLC program
You may advance the ejector while the clamp is still opening the mold, or
wait until the mold is fully open.
Ejector Control