User guide
Load Initial Profile Setpoints
Chapter 8
8-49
Record 1 for one ejector stroke.
The valve spanning procedures in chapter 9 require this initial value. We
help you select a correct final value for your application in chapter 10. For
additional information, refer to the Plastic Molding Module Reference
Manual (publication 1771-6.5.88)
After you determine initial values and record them on Worksheet 8-F, you
are ready to proceed. Refer to procedures in chapter 4 if necessary.
Important: Be sure that you do not alter any setpoints, and that you enter
each and every setpoint exactly as on the worksheet.
1. Enter all worksheet values into your PLC-5 data table.
2. Download command blocks to the QDC module. We repeat EPC
download data.
Block to
Download:
ProSet 600
Block ID:
Download
Bit, B21/:
Companion
Block:
EPC 24 23 none
3. Check SYS61 and SYS62 for programming errors. Correct as needed.
Enter and Download Your
W
orksheet V
alues