User guide
Load Initial Profile Setpoints
Chapter 8
8-18
After you determine initial values and record them on Worksheet 8-B, you
are ready to proceed. Refer to procedures in chapter 4 if necessary.
Important: Be sure that you do not alter any setpoints, and that you enter
each and every setpoint exactly as on the worksheet.
1. Enter all worksheet values into your PLC-5 data table.
2. Download command blocks to the QDC module. We repeat the IPC
block download data.
Block to
Download
ProSet 600
Block ID
Download
Command Bit
Companion
Block
IPC 09 B21/8 none
3. Check SYS61 and SYS62 for programming errors. Correct as needed.
The following two pages contain Worksheet 8-C for the pack/hold profile
(one page for bit entries and one for word entries). The valve spanning
procedures in chapter 9 require specific values. We have already recorded
many values for you on the worksheet. You must determine the remaining
setpoints based on your specific machine.
Important: You record setpoints for a pressure vs. time profile on
Worksheet 8-C. We assist you in determining these values.
Enter and Download your
W
orksheet V
alues
Determine and Record
Setpoints for the
Pack/Hold Profile (HPC)