User guide
Load Initial Configuration Values
Chapter 7
7-31
After you determine your initial values and record them on configuration
worksheets, you are ready to proceed. Refer to procedures in chapter 4 if
necessary.
Important: Be sure that you do not alter any setpoints, and that you enter
each and every setpoint exactly as on the worksheets.
1. Enter all worksheet values into your PLC-5 data table.
2. Download command blocks to the QDC module. For your
convenience, we repeat the table of download information
(Table 7.B) from chapter 4.
Important: Do NOT download companion blocks at this time.
Table 7.B
Information
Required to Download a Block
Block to
Download:
ProSet 600
Block ID.:
ProSet 600 Download
Command Bit in B21:
FCC 03 2
SCC 04 3
TCC 05 4
LPC 06 5
INC 08 7
PKC 10 9
HDC 11 10
PLC 14 13
FOC 17 16
SOC 18 17
TOC 19 18
OSC 20 19
EAC 22 21
ERC 23 22
Enter and Download your
W
orksheet V
alues