Manual

Select Command and Status Bits
to Sequence Machine Operation
Chapter 6
6-5
Table 6.G
Command
Bits to Enable or Disable Ejector Profiles
Bit Description: QDC Block Addr.:
0 = start ejector profile on clamp position
1 = start ejector profile on command
EPC03B08
0 = ejector profile enabled
1 = ejector profile disabled
EPC03B09
0 = run ejector profile without interruption
1 = stop and notify @ end of ejector stroke
EPC03B12
Table 6.H
Miscellaneous
Status Bits to T rigger New Ejector Events
Reason for Using: Bit Description: QDC Block
Addr.:
To shift solenoids before starting next
ejector stroke after the 1st advance
stroke
Ejector profile stopped at end of
stroke
SYS03B08
To prevent starting ejector retract Ejector forward dwell timer is timing SYS03B10
To start ejector retract Ejector fully advanced SYS03B12
To start ejector retract when
tip stroking is ON
Ejector is beyond tip advance position SYS03B13
To start ejector advance when
tip stroking is ON
Ejector is inside tip retract position SYS03B14
To start ejector advance Ejector fully retracted SYS03B15