Manual

Select Command and Status Bits
to Sequence Machine Operation
Chapter 6
6-3
Table 6.C
Command
Bits for Automatic Functions in Clamp and Eject Mode
To initiate this
profile/movement:
Toggle this bit: Or the profile/movement
starts automatically after:
If this bit is
Reset:
1st Clamp Close DYC02B00 - -
2nd Clamp Close DYC02B01 1st Clamp Close CPC03B08
3rd Clamp Close DYC02B02 2nd Clamp Close CPC03B09
Low Pressure Close DYC02B03 3rd Clamp Close CPC03B10
1st Clamp Open DYC02B10 - -
2nd Clamp Open DYC02B11 1st Clamp Open OPC03B08
3rd Clamp Open DYC02B12 2nd Clamp Open OPC03B09
Clamp Open Slow DYC02B13 3rd Clamp Open OPC03B10
First Ejector
Advance
DYC02B14 On Clamp Position During
Open
EPC03B08 and
EPC03B09
Ejector Continue DYC03B15 Previous Ejector Stroke EPC03B12
Table 6.D
Status
and Command Bit Interaction for Automatic Functions
in Clamp and Eject Mode
For this
Profile/Movement:
During Execution
this bit is:
At Completion
this bit is:
At completion
If this Then this
command bit is: status bit is:
SET RESET SET RESET also SET also SET
1st Clamp Close SYS21B00 SYS02B00 SYS02B00 SYS21B00 CPC03B08 SYS22B00
2nd Clamp Close SYS21B01 SYS02B01 SYS02B01 SYS21B01 CPC03B09 SYS22B01
3rd Clamp Close SYS21B02 SYS02B02 SYS02B02 SYS21B02 CPC03B10 SYS22B02
Low Pressure Close SYS21B03 SYS02B03 SYS02B03 SYS21B03 --- SYS22B03
1st Clamp Open SYS21B10 SYS02B10 SYS02B10 SYS21B10 OPC03B08 SYS22B10
2nd Clamp Open SYS21B11 SYS02B11 SYS02B11 SYS21B11 OPC03B09 SYS22B11
3rd Clamp Open SYS21B12 SYS02B12 SYS02B12 SYS21B12 OPC03B10 SYS22B12
Clamp Open Slow SYS21B13 SYS02B13 SYS02B13 SYS21B13 --- SYS22B13
Ejector Advance SYS21B14 SYS02B14 SYS21B14 SYS02B14 EPC03B12 SYS22B14
Intermediate Ejector
Retract
SYS21B14 SYS02B14 SYS21B14 SYS02B14 EPC03B12 SYS22B15
Final Ejector Retract SYS21B14 SYS02B14 SYS02B14 SYS21B14 --- SYS22B15