User Manual

Select Command and Status Bits
to Sequence Machine Operation
Chapter 6
6-5
Table 6.E
Miscellaneous
Status Bits T o T rigger New Inject and Clamp Action
Reason for Using: Bit Description: QDC Block
Addr.:
To drop pump adders, or shift solenoids before
starting pack/hold profile
Injection complete SYS02B04
To inhibit clamp from opening in auto mode Cure timer timing SYS03B03
To start clampopen phase Ram (screw) retracted, and
Cure time complete
SYS03B04,
and
SYS03B05
To idle the machine and activate an alarm
because the hopper is running out of plastic
Watchdog for plastication
phase
SYS04B08
To shift solenoids for predecompression Setoutput in progress @ end
of hold
SYS22B06
To shift solenoids for plastication Setoutput in progress @ end
of predecompression
SYS22B07
To shift solenoids for postdecompression Setoutput in progress @ end
of plastication
SYS22B08
To idle the machine until starting next action Setoutput in progress @ end
of postdecompression
SYS22B09
To drop pump adders, or shift solenoids Clamp in moldprotect zone SYS03B00
To add pump adders, or shift solenoids for
tonnage build or lockup
Mold safe SYS03B01
To start inject cycle Tonnage complete SYS03B02
To drop pump adders, or shift solenoids Clamp in openslow zone SYS03B06
To idle the machine until starting next action Mold fully open SYS03B07
To prevent starting next cycle when machine is
in auto mode
Opendwell timer is timing SYS03B09
To start next cycle with machine in auto mode Cycle complete SYS03B11
To reopen the clamp when the part is stuck LP close watchdog timeout SYS04B03