User Manual

Select Command and Status Bits
to Sequence Machine Operation
Chapter 6
6-4
Table 6.D
Command
Bits T o Interrupt Inject and Clamp Movement Between Profiles
Bit Description: QDC Block Addr.:
0 = start 2nd clamp close profile @ endof 1st
1 = stop and setoutput @ endof 1st
CPC03B08
0 = start 3rd clamp close profile @ endof 2nd
1 = stop and setoutput @ endof 2nd
CPC03B09
0 = start LP close profile @ endof 3rd
1 = stop and setoutput @ endof 3rd
CPC03B10
0 = start 2nd clamp open profile @ endof 1st
1 = stop and setoutput @ endof 1st
OPC03B08
0 = start 3rd clamp open profile @ endof 2nd
1 = stop and setoutput @ endof 2nd
OPC03B09
0 = start clamp open slow profile @ endof 3rd
1 = stop and setoutput @ endof 3rd
OPC03B10
0 = start predecompression movement @ endof hold
1 = stop and set output @ endof hold
HPC03B08
0 = start plastication profile @ endof predecompression
1 = stop and set output @ endof predecompression
HPC03B09
0 = start postdecompression movement @ endof plastication
1 = stop and set output @ endof plastication
PPC03B08