User Manual

Index
I–3
OSC start position, 835, 1028
outputs
select ranges, 33
set-output, end of profile, 734
to selected valve
pressure control, 729
velocity control, 728
to unselected valves, set output values,
731, 1015
overview of manual, P1
P
pack phase, example benefits, 17
pack profile
initial values, 817
overview, 16
plastication
example benefits, 19
initial profile values, 823
overview, 18
post-decompress movement, 19
power distribution, 212
pre-decompress movement, 18
pressure setpoints, 814
CPC, 86
IPC, 814
LPC, 1025
OPC, 834
PPC, 827
tuning of, 1011
pressure-limited injection, 1021
diagram, 1022
ram pressure limit, 815
start zone for, 815
time delay for, 815
profile requirements
clamp mode, 1025
inject mode, 1010
min requirements, 1013
publications, related, P5
pullback, decompression, 1017
Q
QDC module
calibrate, 113
digital input filter, 317
ground, 29
I/O ranges, 32
I/O terminal designations, 28
install, 26
optional configurations, 314
select parameters, 31
sensor config values, 33
sensor configuration, 38
set jumper plugs, 22
troubleshoot, 111
wire I/O, 27
QH module, record I/O ranges, 21
R
ramp rates
clamp mode, 1030
initial values, 733
inject mode, 1018
S
sensor config values, 33
sensor configuration, 38
set-output values
at end of clamp profiles, 1029
at end of inject profiles, 1017
for unselected valves, 1015
shot size, 829, 1014
diagram, 1015
software travel limits, 314
status blocks, P4, 42
T
time delays, 316
time setpoints, 1012
HPC, 821
IPC, 815
PPC, 828
tonnage, procedure to set, 97
tonnage-complete setpt, 88
transition, 16, 816, 1014
conditions for, 1013
diagram, 1015
troubleshoot, 111
tune closed loop
pressure control, 102
with an oscilloscope, 104
without an oscilloscope, 103
velocity control, 106
with an oscilloscope, 108
without an oscilloscope, 107
tuning considerations
for clamp operation, 1024