User Manual

Select System Operation with bits 05 and 04
Inject and Clamp 0 1
Select Singleunit Operation with bit 03 = 1
(0 generates a programming error)
Select English = 0 or
metric = 1 with bit 00
Code:
Your value
Required initial value
loaded by ProSet 600
0 or 1
Select Input 1 (Screw Position) Range with bits 01, 00
Select Input 2 (Screw Pressure) Range with bits 03, 02
Select Input 3 (Clamp Position) Range with bits 05, 04
Select Input 4 (Clamp Pressure) Range with bits 07, 06
Input Range
0 - 10V dc 0 0
1 - 5V dc 0 1
4 - 20 mA 1 0
Not connected 1 1
Code:
Your value
Required initial value
loaded by ProSet 600
0 or 1
Appendix
A
A-1
Blank Worksheets
Worksheet 3A
Selecting Module Parameters
Control W ord MCC02Bxx 15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
ProSet 600 Addr. B34/bit 543 542 541 540 539 538 537 536 535 534 533 532 531 530 529 528
Value 0 0 0 0 0 0 0 0 0 0 0 0
Example: If you select Inject and Clamp operation with English units:
MCC02 = 00000000 00011000
Worksheet 3B
Selecting Input Ranges for your Sensors
Control W ord MCC03Bxx 15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
ProSet 600 Addr. B34/bit 559 558 557 556 555 554 553 552 551 550 549 548 547 546 545 544
Value 1 1 1 1 1 1 1 1
Example: If you select an input range of 4-20 mA for all four inputs:
MCC03 = 11111111 10101010.
Important: Software input selections must match the jumper settings for
each respective input.