User Manual

Preface
P-5
The following table lists documentation necessary for the successful
application of the QDC Module:
Publication Use this documentation: To:
17856.6.1 PLC5 Family Programmable
Controller Installation Manual
Install the PLC5 processor and I/O modules.
6200N8.001 6200 PLC5 Programming
Software Documentation Set
Select instructions and organize memory when
writing ladder logic to run your machine.
17714.10 Plastic Molding Module
Application Guide
Help select the module mode and match your QDC
module to your hydraulic layout.
17716.5.85 Plastic Molding Module User
Manual, Inject Mode
Configure, program, install, and operate your QDC
module to control inject operations.
17716.5.87 Plastic Molding Module User
Manual, Clamp & Eject Mode
Configure, program, install, and operate your QDC
module to control clamp and eject operations.
17716.5.88 Plastic Molding Module
Reference Manual
Program block transfers between PLC5 processor
and QDC module. PLC5 data transfer logic.
17716.5.93 Plastic Molding Module User
Manual, Inject, Clamp & Eject
Mode
Configure, program, install, and operate your QDC
module to control inject, clamp, and eject
operations.
Take time now to familiarize yourself with the Reference Manual
(publication 1771-6.5.88). The four sections include:
a summary of each data block used by the QDC module
(abbreviated command and status blocks)
programming error codes returned by the QDC module for each data
block, and recommended procedures to correct these errors
detailed listing and explanation of each command word and bit used by,
and each status word and bit returned from, the QDC module
operational, electrical, and environmental specifications of your module
If you purchased the Pro-Set 600 software, you also need the following:
Publication Use this documentation: To:
65006.5.11 ProSet 600 Software
Designers Guide
Select the ProSet 600 software that matches
the requirements of your molding machine.
65006.5.12 ProSet 600 Software
Assembly Manual
Transfer your ProSet 600 software from a
floppy disk to your hard drive. Add Overlays into
your PLC5 and PanelView application files.
65006.5.13 ProSet 600 Software
Overlay Installation Manual
Install ProSet 600 overlays into your application
files.
65006.5.14 ProSet 600 Software
Customization Manual
Customize your ProSet 600 build for your
machine control requirements.
65006.5.15 ProSet 600 Software
Reference Manual
Support customizing your software control
system.
Related Publications