Instruction Manual

Select Command and Status Bits
To Sequence Machine Operation
Chapter 6
6-5
Table 6.G
Command
and Configuration Bits
Category Function Enabled
(when = 1)
ProSet
B34/___
QDC Block
Address
Nonprofiled execute setoutput 392 DYC01B08
Action Commands execute screw rotate jog 393 DYC01B09
execute inject cylinder forward jog 394 DYC01B10
execute inject cylinder reverse jog 395 DYC01B11
execute unassigned #4 jog 396 DYC01B12
execute unassigned #5 jog 397 DYC01B13
execute unassigned #6 jog 398 DYC01B14
execute unassigned #7 jog 399 DYC01B15
Profiled execute injection profile 404 DYC02B04
Action Commands execute pack profile 405 DYC02B05
execute hold profile 406 DYC02B06
execute predecompression movement 407 DYC02B07
execute plastication profile 408 DYC02B08
execute postdecompression movement 409 DYC02B09
Stop Command execute all stop (outputs = zero) 415 DYC02B15
Miscellaneous reset cure timer 417 DYC03B01
Commands reset SYS01B08 424 DYC03B08
reset latched alarms 425 DYC03B09
reset complete bits (SYS02) 426 DYC03B10
Logical Bridge
Configuration
set output at end of hold profile
(0 = start predecompression movement at end of hold)
B38/296 HPC03B08
set output at end of predecompression movement
(0 = start plastication profile at end of predecompression)
B38/297 HPC03B09
set output at end of plastication profile
(0 = start postdecompression movement at end of plastication)
B38/488 PPC03B08