Instruction Manual

Index
I–4
tune closed-loop
pressure control
general guidelines, 102
with an oscilloscope, 104
without an oscilloscope, 103
velocity control
general guidelines, 105
with an oscilloscope, 107
without an oscilloscope, 106
tuning considerations for profiles
end-of-segment positions, 1010
minimum requirements, 1011
time setpoints, 1010
tuning considerations, for, profiles
pressure setpoints, 109
velocity setpoints, 108
tuning constants, initial, 725
V
valve-linearity procedures, for, plastication
screw RPM, 928
valve-linearity test procedures, for
injection pressure, 95
injection velocity, 911
pack and hold pressure, 917
plastication backpressure, 923
valve-spanning procedures, for
injection pressure, 92
injection velocity, 97
pack and hold pressure, 913
plastication pressure, 920
plastication screw RPM, 925
velocity control limits, 722
velocity setpoints, 85
tuning, 108
velocity units, 84
W
watchdog timer, preset, tuning, 1018
watchdog timer preset, 726
worksheets
alarm/time-delay setpts, 316, A5
blank copies, A1
clamp jog config values, 58, A7
HDC initial config values, 78
HPC initial profile values, 810, A20
INC initial config values, 74
IPC initial profile values, 82, A18
PKC initial config values, 76
profile, PPC values, 816, A22
QDC module parameters, 32, A1
ram jog config values, 53, A6
select output ranges, 33, A2
sensor input ranges, 33, A1
sensor-config values, 35, 310, A3,
A4
software travel limits, 315, A5
Worksheets, for, I/O ranges, 21