Instruction Manual

Index
I–3
logical bridges, 812, 818
tuning, 1015
N
numbering, bit and word, P4
O
offset, 821
sign, 84, 812, 818
tuning considerations, 1018
value, 87, 815
outputs, selected valve for screw RPM,
712
P
pack phase overview, 15
pack profile example benefits, 16
PID algorithm, select type of, 714
plastication overview, 17
Plastication Phase, example profile, 18
position setpoints, 86, 820
power distribution, 212
pre-decompression overview, 17
pressure alarm setpoints
initial values, 725
tuning considerations, 1018
pressure control limits
cavity, 720
ram (screw), 719
pressure setpoints, 86
tuning, 109
pressure-limited injection
ram pressure limit, 87, 1020
start zone for, 87, 1020
time delay for, 87, 1020
tuning considerations, 1019
profile, min requirements for, 1011
profile alarm procedures, for
injection pressure, 96
pack and hold pressure, 919
plastication backpressure, 924
Q
QDC module
calibration, 112
inputs and outputs, 28, 31
set jumper plugs, 22
troubleshooting, 111
QH module, record I/O ranges, 21
R
ram pressure setpoints, 814
ramp rates
accel/decel tuning, 1016
initial values, 718
related publications, P4
S
Screw RPM, 18
screw RPM
algorithm selection, 818
control limits, 723
plastication phase, 18
profile offset, 818, 821
selected control valve, 712
setpoints
position, 820
RPM, 819
time, 821
span plastication valve, 925
test valve linearity, 928
screw speed, values for RPM sensor, 313
set-output values
end-of-profile tuning, 1015
end-of-profile, initial, 718
unselected valve tuning, 1013
unselected valves, 716
setpoints, screw RPM, 819
shot size, 821
tuning considerations, 1012
software travel limits, 314
status blocks, P3
used during configuration, 42
T
time setpoints, 87, 814, 821
tuning, 1010
transition
overview, 15
setpoints, 88
start zone for pressure, 1013
tuning considerations for, 1012
troubleshooting, 111