Instruction Manual

Symbols
**Empty**, 18, A1
A
algorithm, select for profile, 818
audience, P2
Auxiliary analog inputs, 21
B
backpressure setpoints, 820
C
calibration of QDC module, 112
cavity pressure setpoints, 814
command blocks, P3
configuration of, 41
special for configuration, 42
Complex Applications, clamp and eject
mode, 11
configuration procedures
concepts, 41
enter config values, 36
overview of entire, 43
control limits, screw RPM, 723
cure timer preset, 815
cushion size, 821
tuning considerations, 1012
D
Decompression Movements,
post-decompression, 18
decompression pullback, 1016
digital filter, 317
download procedures
config initial values, 726
correct dataentry errors, 46
data blocks, 44
enter into data table, 44
HPC profile values, 815
IPC profile values, 89
jog initial values, 54
PPC profile values, 822
QDC module config values, 36
E
E-Stop, 211
end-of-segment setpoints, 86, 820
tuning, 1010
ERC, tuning considerations, 1021
error correction for, data entry in, data
blocks, 46
F
flash prevention, 14
G
gain constants (PID), 714
glossary, P2, 11
H
hold phase overview, 17
I
I/O
auxiliary analog inputs, 21
record ranges, 21
I/O config procedures (optional)
digital filter, 317
RPM and pressure alarms, 316
software travel limits, 314
I/O configuration procedures, 31
cavity pressure sensor, 313
correct program errors, 37
download config values, 36
move the ram (screw), 38
ram position sensor, 311
ram pressure sensor, 312
screw RPM sensor, 313
select I/O sensor ranges, 32
sensor config valves, 34
sensor configuration, 39
inject mode overview, 11
Inject Phase
plastication phase, example profile, 18
screw RPM, 18
injection phase overview, 12
Index